Specifications
Construction
HULL
- KEVLAR/GLASS COMPOSITE. VACUUM BAG
- PRE-PREG EPOXY RESIN
- BALSA IN HIGH LOAD AREA
- FOAM CORED TOPSIDES
- BALSA CORED BOTTOM
DECK
- E-GLASS & VINYLESTER RESIN
- FOAM CORE IN LOW LOAD AREAS
- HIGH DENSITY COMPOSITE UNDER DECK GEAR
LEAD KEEL, EPOXY PRIMED 4% ANTIMONY 316 SS BOLTS
ANODIZED ALUMINUM STRUCTURAL FRAME FOR RIG/KEEL LOADS
TOPSIDES GELCOAT IN LIGHT COLORS
MECHANICAL
DIESEL ENGINE: VOLVO MD2040 40HP DIESEL SAILDRIVE
ALTERNATOR: 60 AMP/12 VOLT
TWO BLADE GEARED BRONZE FOLDING PROP 17 X 14
FUEL TANK: 38 GALLON WITH REMOTE GAUGE
FUEL FILTER & WATER SEPARATOR RACOR 230R
WATER LIFT MUFFLER
SINGLE LEVER THROTTLE & CLUTCH CONTROL
ELECTRICAL
12 VOLT DC SYSTEM 12 VOLT DC DISTRIBUTION PANEL
- BATTERY CONDITION METER
- MAIN CIRCUIT BREAKERS OF APPROPRIATE AMPERAGE
- MAIN BATTERY SWITCH (1)
BATTERIES: 2 (EACH) GROUP 27, 105 AH. HOUR LEAD ACID
ALTERNATOR: 60 AMP/12 VOLT
ORC APPROVED RUNNING LIGHTS
HALOGEN LIGHTS GENERAL ILLUMINATION
DOME LIGHTS & SPOT LIGHTS
12 VDC OUTLET AT NAV STATION
AC SHOREPOWER (OPTIONAL)
PLUMBING & STOVE & REFRIGERATION
WATER TANK: 1 X 40 GALLON CAPACITY
HOT & COLD PRESSURE WATER SYSTEM
SINGLE S/S GALLEY SINK
VANITY SINK IN HEAD
MANUAL BILGE PUMP: DIAPHRAGM - 10 GPM ON DECK
MARINE HEAD W / HOLDING TANK & DOCKSIDE DISCHARGE
FLUSH SEACOCKS ON ALL OPENINGS BELOW WATERLINE
STOVE: 2-BURNER PROPANE STOVE & OVEN
ICE BOX WITH PUMP OUT
WATER HEATER - 6 GAL., S/S
DECK HARDWARE
WINCHES:
- PRIMARIES: HARKEN B48.2 (2)
- HALYARDS: HARKEN B44.2STA (2)
- MAINSHEET: HARKEN B44.2STA (2)
- WINCH HANDLES: 10" DBL GRIP LOCK IN (2)
8"SINGLE GRIP LOCK IN (1)
(LEWMAR WINCHES OPTIONAL)
LIFELINES: UPPER & LOWER 1 X 19 S/S WIRE
STAINLESS BOW RAIL, STERN RAIL & STANCHIONS
SPINLOCK CLUTCH XT FOR HALYARDS
SPINLOCK ROPE CLUTCHES FOR CONTROLS
CUNNINGHAM
12:1 OUTHAUL LEAD AFT TO COCKPIT
MAINSHEET: 2:1 LEAD AFT TO WINCHES
MAINSHEET TRAVELLER 6:1
12:1 JIB CAR CONTROLS
2 REEF LINES WITH LOCK-OFFS IN BOOM
HATCHES & VENTILATION:
- FOREDECK HATCH (1)
- OPENING PORTS (4)
- CABIN HATCH (1)
- HATCH OVER HEAD (1)
- FOREPEAK VENT (1)
ANCHOR LOCKER, SELF DRAINING
FORWARD MOORING CLEAT, 8" S/S RETRACTABLE (2)
STAINLESS STEEL HANDRAILS ON CABIN TOP
STEERING
RUDDER STOCK, HARDCOAT ANODIZED ALUMINUM
ANODIZED ALUMINUM RADIAL DRIVE
RUDDER BEARINGS UPPER & LOWER
EMERGENCY TILLER: ALUMINUM
WHEEL 60" STAINLESS STEEL
STEERING COMPASS 5" DIA (OPTIONAL)
SPARS & RIGGING
CUSTOM HALL SPAR CARBON RIG
- TAPERED FRACTIONAL 2-SPREADER
- MAINSAIL TRACK FOR ANTAL BATT SLIDES
- SPARTITE INCLUDED
- CLEAR COAT CARBON FINISH
ALUMINUM BOOM, W/ OUTHAUL & 2 REEFS W/ LOCK OFFS
ROD RIGGING NAVTEC SERIES 500, DISCONTINUOUS
HOOD SEAFURL ROLLER FURLER SIZE 253, C-EXTRUSION
-10 INTEGRAL HYDRAULIC BACKSTAY CYLINDER
VANG: HALL QUIK VANG, LEAD AFT
OUTHAUL: 12:1 LEAD AFT TO COCKPIT
CARBON RETRACTABLE SPRIT
ALL APPROPRIATE BLOCKS AND HARDWARE FOR ABOVE
RUNNING RIGGING
MAIN HALYARD (1) SPECTRA
SPINN HALYARD (1) SPECTRA TO MASTHEAD
JIB HALYARD (2) SPECTRA
MAINSHEET (1) 2:1 SPECTRA
JIB SHEET (2) SPECTRA
SPINN SHEET (2) SPECT-SET II W/ SS SHACKLE
TRAV. CONTROL (1) DACRON
CUNNINGHAM (1) STA-SET X LITE
JIB CAR TACKLE (2) SPECTRA
ROLLER FURL LINE (1) DACRON
MISCELLANEOUS
DECK MAY BE ONE COLOR OR TWO TONE (OPTIONAL)
SINGLE BOOTSTRIPE IS STANDARD (IF ORDERED BEFORE MOLDING)
BOTTOM FINISHED IN EPOXY READY TO SAND & PAINT
FOILS ARE EPOXY COATED AND FAIRED
FIXED BERTHS 125MM CUSHIONS
CABIN TABLE
MARINE FIRE EXTNGUISHER
ONE DESIGN
GUARANTEED TO COMPLY WITH FARR 395 ONE DESIGN CLASS RULES UPON DELIVERY
CE-CERTIFICATION
The FARR 395 One Design has been built in accordance with the European CE-Certification and meets the requirements for Category A of the CE-directive 94/25/EC for recreational crafts.
These rules require a certain minimum standard of hull and deck strength, structural bulkheads and stringers, keel, and rudder and their attachments to the hull, safety and stability, engine installation, gas installation, sea cocks, manuals and documents of all major installations.
THESE DIMENSIONS & SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
